No more images of this coach on this site ...

4-29-08

I just realized we put up an image yesterday  that didn't show the new wipers. This how it looks now,
Note the front bumper a little out of alignment. plus the door needs to be realigned also .
It is rubbing on the inside aluminum trim next to upper hinge . .

4-28-08
Working on final completion list

New D.O.T. Safety Lock, Note size difference along with the safety pins over the other lock .


Image taken 3-25-08

Upper door trim made and sized

Lower door rub rail designed and made.


Non D.O.T. RV Latch,
We were told they were when  we purchased them.
Now we have two cases of RV Locks that are worthless.
On this model the throw is too small and as the bus chassis twist it
actually can disengage and let the door open .


40% Larger handle and throw with stabilizer pins
DOT Approved door won't try to open on it's own


Door rubbing ..Door needs to be realigned, It is too tight against the front end...
                                                                                                        Note rubbing on aluminum rail

Bumper is not aligned correctly  and  is scrubbing against stainless steel .

 

4-9-08

Lower ribbed stainless steel entrance door panel mounted ..


Note blue panel to the left . This is the upper panel after cutting for the RV lock, waiting to be installed.


Had to build a plate for the bottom of the wiper motors.


Console trim pieces made and ready to install .

Catalytic Converter Muffler was clogged.  It seems to help a little when cleaned out .
This muffler is designed to be opened and cleaned once every 5 -8 years

Air Breather on top of muffler

2-5-08
Co-pilot seat  mounted to the floor

1-21-08

Very heavy Co-Pilot seat mounting,
Designed, built and installed

Mounting Table with new brace

 

Rope lighting had a failure

1-14-08
Sanding for second coat of paint to drivers console...



Wood trim to accent the driver console..

More work on co-pilot seat




Top of windshield painted to lower sun blindness like the commercial buses do.

TV reinstalled

1-12-08
Table Bracket designed built and painted


Drivers Console stripped of bad upholstery, cleaned and painted .

Heavy 1/4" plate steel designed and built to mount co-pilot seat through the floor into
the super structure.
Then we installed heavy bolts and welded the heads to the plate on the bottom side

12-04-07
Moved Borrowed swivel chair back to 3336 see below

12-03-07

 They had been working on the TV, Back up camera, new shift console and the Generator controls and
drilling holes to mount passenger seat.

Had to remove the TV to get to the wiring for the Generator and Back up camera,..
Note the TV is sitting  where the Chair was ,..the chair was sitting just outside the door .  .



Same Chair located back next to 3336

The rest of the coach

 

Don't worry,  there's a lot more .

"See our new Online  RV Catalog "
 
 
 www.BusRVparts.com
 
 Need help?,...Call our ...
 Free Advice Hotline
 610-767-8000