Limo Bus Shell
Production Unit : 6538

Please Note :
These are technical images and are used for engineering purposes only ...
Due to proprietary reasons. Some processes and techniques are not shown .

Before & After 
  

You will have to paint under the windshield to get the black wrap around effect.

 3-8-08

Last skins to go on this morning

 

Temp after road test is perfect, between 170 and 190 degrees .

We noticed the hot exhaust was closer then we felt it should be to the water return to the engine,
so we wrapped it with muffler heat protector cloth . .

3-11-08
Vanner Battery equalizer

Battery equalizer, permits 12Volts, i.e. LED lighting, headlights, marker lights, brakes lights, turn signals etc.
and other  accessories to run off both batteries at the same time so as not to hurt one battery with a huge 12 volt drain.

3-7-08

Bad circuit in charging system,..found Voltage regulator bad ...removed and replaced


Checked out heater blower, ..greased and serviced



 

Inspection panels to access the new upper tail lights

Removed serviced and replaced  windshield wiper motors
 

Added rear bumper tips


 

Repaierd damged door


Installed stainless steel rear license plate panel with light 


Light

3-6-08

3-5-08
Ceiling finished


Trim finishing 

Almost all the decorative trim installed, one last piece beside door left . 

All wheels painted several coats of heavy enamel.


Back wall finally painted


 

After our discussion on 24Volt light bulbs we converted all light bulbs on outside to 12Volt

Not cleaned up yet

3-3-08

New modern MCI "E" model Front end installed


Mirror mounts installed

Low beam light test ,...High Beam light test

Radiator  screen installed

Left turn signal corner installed

Painted tires over the week end . added final coat today


Cleaned lug nuts
 

Painted upper  windshield and added more insulation

2-27-08
Engine almost ready to install

Engine compartment had some bad wiring but we taking care of it .

Painting chassis .

Painting engine parts to look better

Trim starting to be installed

Note the upper and lower trim

Installing entrance door

Rear turn Signals

Install Wiring front cap and marker lights.

 Rear End

2-13-08
Flooring almost done ..now working on ceiling

Cleaned and painted full bay

Salon Door stripped and prepped to be installed

Older Ribbed luggage bay doors removed, preparing to install flat skin doors

Cleaning luggage  Bay compartments